We don’t imply to toot our own horn, however we’ve been doing this curtain track thing for a while now, and we’re fairly good at it. Through the years we have now discovered many lessons about the very best ways to install curtain tracks. A lot of our clients are staunch do-it-yourselfers, which we applaud. Allow us to avoid wasting you some trial and error by sharing some of the most helpful ideas and tricks we’ve collected.

GETTING STARTED

Nearly any curtain track installation project could be accomplished with a drill, miter or hack noticed, screw driver, tape measure, and level. If you happen to’ve bought these readily available, the subsequent step is to recollect some suggestions which might be useful for any project: ask for assist; and measure twice, lower once.

SEEING IS BETTER THAN VISUALIZING

Earlier than you cut a track or drill a hole – lay everything out on the floor in front of you. Take note of the relative positions of the curtain track, material hardware, and curtain panels. Consider how the curtains will stack, where they will hit the highest of the track, the general length of the curtain panels, and the area between panel and floor. Adjust as needed via hook position or tape height.

KEEP YOUR DISTANCE

We don’t care what you use to measure the gap from the ceiling to your wall-mounted bracket – so long as you utilize the identical thing for each bracket. So seize your stage, ruler, block of wood, no matter – just use it consistently. Do the same for keeping a constant distance from the wall and your ceiling-mounted track.

GLIDE IN FIRST

Trust us on this one – when utilizing hooks in your curtains, put your carriers or glides onto the curtain track before the track is positioned on the ceiling or wall. If you happen to’ve obtained a snap tape system, snap the carriers onto the curtain and then slide the carriers into the track.

SPLICE AND DICE

When splicing tracks together, use the factory-cut sides for splicing, fairly than the hand cut. We’re certain you’re a fair hand with your miter saw, however the factory minimize end is bound to be square and will facilitate a better joint.

If you loved this short article and you would such as to obtain more info pertaining to curtain track system kindly see our site.